English
Removing the protective film
Carefully remove the protective film from the outer surfaces of the appliance,
so that no glue residue is left behind. Any remaining residue can be removed
using a suitable solvent product.
Removing the protective silicone from the tip of the core probe
Fitting the fixed appliance feet
The feet supplied in the bag inside the packaging ensure sufficient airflow for
the cooling of electronic components and the outer surfaces of the oven. It is
therefore essential that they are fitted correctly. Install the feet at the points
indicated in the illustration.
Caution! Do not use the oven without feet; this could cause the electronic
components to overheat, damaging them beyond repair.
Drip drawer
The drip drawer fixed to the back panel of the oven collects any liquids deposited on the inside of the oven
door, thereby preventing them from dripping onto the floor when the door is opened.
Remove the drip drawer from the rear of the oven using a screwdriver, slide the runners (supplied in the bag
inside the oven) into position and insert the drawer as illustrated in the figure.
34
Appliance installation
To Next Page
Loading...
Need help?
General