Preparation before Use
2-14
13 Check if all the address entries are correct and
press [OK].
14 After changing the setting, restart the network from
the system menu, or turn the machine OFF and
then ON.
For detailed information on restarting the network,
refer to Restart Network on page 9-106.
DHCP Settings
Select whether or not to use the DHCP server. The default setting is On.
Use the procedure below.
1 Press the System Menu key.
2 Press [System], [Next] of Network and then [Next]
of TCP/IP Setting.
3 Press [Change] of TCP/IP.
4 Press [On] and then press [OK].
5 Press [Change] of IPv4.
6 Press [DHCP].
7 Press [On] or [Off] of DHCP and then press [OK].
8 After changing the setting, restart the network from
the system menu, or turn the machine OFF and
then ON.
For detailed information on restarting the network,
refer to Restart Network on page 9-106.
Bonjour Settings
Select whether or not to use Bonjour. The default setting is Off.
Refer to Bonjour Settings on page 9-95 about the procedures.
To Next Page
Loading...
Need help?
General
