DE35-ST Operating Instructions
D292469I 41
ii. Press the NO key at this time will take you to QUIT MENU for the
OUTPUT SELECT menu. Pressing the YES key again will take you
back to QUIT MENU.
i. Press the Output Sizes key.
Select/Enter Waffle Pack part number.
i. Move the cursor to PATTERN NUMBER and press the YES key.
The first digit of the 6-digit P/N will be flashing.
ii. Using the Keyboard, enter the Waffle Pack number you are going
to use and press the YES key. For example, if the waffle pack
number is H20-55-24 then enter 000055-24. The H20 indicates a
2” waffle pack.
iii. The display will say either Catalog or New Pattern #. If it is a
catalog pattern number the dimensions will be automatically
loaded. If it says NEW, go to the Programming Your Own Waffle
Pack chapter before proceeding.
Note: There are 250 programmed waffle packs in the system.
iv. Press the NO key to return to QUIT MENU, press the YES key to
quit.
4. Install Waffle Packs.
To install the waffle packs onto the output stage, release the clamp pins by
pulling on the fluted edges of the clamp plates at each corner of the output
tooling plate. The waffle packs should be installed so that the corner bevel is
towards the front and facing to the left hand side of the machine. This insures
the X and Y pitch orientation is correctly aligned If the waffle pack cavities are
rectangular.
To Next Page
Loading...