40 D292469I
iii. Use the +/- buttons on the keypad until the desired grade is
shown. Output Grade choices will appear as follows:
• 1 Output Grade
• 2 Output Grade
• 3 Output Grade
• 4 Output Grade
iv. Press Yes to save.
Note: Each tray can be assigned a different grade or all trays can be assigned the
same grade. The system will not allow more grades than the number of trays
available on the Output Fixture.
f. >PLACEMENT PATTERN – FULL
Select desired Placement Pattern.
i. Press the YES key to toggle between FULL/CHECKERBOARD
pattern options.
ii. Use the ARROW key to move the cursor down to the next line
item of the menu.
g. >INSPECTION OPTIONS - SUB MENU
Select desired Inspection option(s).
i. Press the YES key. A Sub Menu will open and allow you to select
available inspection options.
• >INSPECT DIE FACET – SELECTED
The YES key will toggle between SELECTED/NOT SELECTED.
• >ROTATE DIE XXX DEG DURING INSPECTION
Press the Yes key to toggle between 90 and 180 degrees.
• >INSPECT UNDERSIDE - SELECTED
Press the YES key to toggle between SELECTED / NOT SELECTED.
ii. When selections are complete, press the NO key to return to the
QUIT MENU. Press YES to quit the Sub Menu and return to the
OUTPUT SELECT menu.
h. >QUIT MENU
i. Press the YES key to exit the menu and return to the operational
program. The output table will perform a reset.
To Next Page
Loading...