8
vacon • 78 Options
Local contacts: http://drives.danfoss.com/danfoss-drives/local-contacts/
Figure 55. Mounting of the keypad.
Figure 56. Keypad mounted onto the drive. Tighten the fixing screws of the cable connector (to
0.5 Nm or 4.5 lb-in) to the enclosure of the drive. This is to keep the high IP66 protection degree
of the drive.
3
• Connect the keypad to the drive and plug the cable on the HMI connector as
shown in the Figure 55 and in the Figure 56.
To Next Page
Loading...
