8
vacon • 82 Options
Local contacts: http://drives.danfoss.com/danfoss-drives/local-contacts/
8.2.5 VACON
®
keypad with graphical display
The graphical keypad features an LCD display and 9 buttons.
8.2.5.1 Keypad display
The keypad display indicates the status of the motor and the drive and any irregularities in motor or
drive functions. On the display, the user sees information about
his
present
location in the menu
structure and the item displayed.
8.2.5.2
Main menu
The data on the control keypad are arranged in menus and submenus. Use the Up and Down arrows
to move between the menus. Enter the group/item by pressing the OK button and
return
to the for-
mer level by pressing the Back/Reset button.
The
Location field indicates your current location. The Status field gives information about the
present status of the drive. See Figure 60.
Figure 60. Main menu.
8.2.5.3
Using the graphical keypad
Editing values
The selectable values can be accessed and edited in two different ways on the graphical keypad.
Parameters with one valid value
Typically, one parameter is set one value. The value is selected either from a list of values (see ex-
ample below) or the parameter is given a numerical value from a defined range (e.g. 0.00...50.00
Hz).
Change value of a parameter following the procedure below:
1. Locate the parameter.
2. Enter the
Edit mode.
3. Set new value with the arrow buttons up/down. You can also move from digit to digit with the
arrow buttons left/right if the value is numerical and then change the value with the arrow but-
tons up/down.
4. Confirm change with OK button or ignore change by returning to previous level with Back/
Reset button.
To Next Page
Loading...
