Vacon 100 X - Page 85

Options vacon • 83
Local contacts: http://drives.danfoss.com/danfoss-drives/local-contacts/
8
Figure 61. Typical editing of values on graphical keypad (text value).
Figure 62. Typical editing of values on graphical keypad (numerical value).
Parameters with checkbox selection
Some parameters allow selecting several values. Make a checkbox selection at each value you wish
to activate as instructed below.
Figure 63. Applying the checkbox value selection on graphical keypad

Start/Stop Se tup
Rem Control Place
I/O Control
KeypadStopButton
Yes
Start Funct ion
Ramping
STOP READY I/O
ID:172 M3.2.1

Edit
Help
Add to favorites
Rem Control P lace
STOP READY I/O
ID: M3.2.1

Rem Control P lace
STOP READY I/O
M3.2.1
I/O Con trol
Fieldbu sCTRL

Start/St op Setup
Rem Control Plac e
I/O Control
KeypadStopButton
Yes
Start Function
Ramping
STOP READY I/O
ID:172 M3.2.1

Rem Control P lace
STOP READY I/O
M3.2.1
I/O Con trol
Fieldbu sCTRL
OR:
OK
OK
OK
BACK
RESET
9257.emf
OK
9256.emf
...
OK
Symbol for checkbox selection