7
vacon • 136 Control keypad
Local contacts: http://drives.danfoss.com/danfoss-drives/local-contacts/
Figure 75. Activation of Start-up wizard
Multimonitoring items (P6.5.4)
VACON
®
alpha-numeric keypad features a display where you can monitor even three actual values
at the same time (see Chapter 7.3.1 and Chapter Monitoring values in the manual of the application
you are using). On page P6.5.4 of the System Menu you can define if it is possible for the operator to
replace the values monitored with other values. See below.
Figure 76. Enabling the change of multimonitoring items
7.3.6.6
Keypad settings
In the Keypad settings submenu under the System menu you can further customise your AC drive
operator interface.
Locate the Keypad settings submenu (S6.6). Under the submenu, there are four pages (P#)
associated with the keypad operation:
Figure 77. Keypad settings submenu
Default page (P6.6.1)
Here you can set the location (page) to which the display automatically moves as the Timeout time
(see below) has expired or as the power is switched on to the keypad.
If the Default Page value is 0 the function is not activated, i.e. the last displayed page remains on the
keypad display. Press the Menu button right once to enter the edit mode. Change the number of the
Main menu with the Browser buttons. Pressing the Menu button right once again makes you able to
edit the number of the submenu/page. If the page you want to move to by default is at the third level
To Next Page
Loading...
