Control keypad vacon • 137
Local contacts: http://drives.danfoss.com/danfoss-drives/local-contacts/
7
repeat the procedure. Confirm the new default page value with the Enter button. You can return to
the previous step anytime by pushing the Menu button left.
Figure 78. Default page function
Default page in the operating menu (P6.6.2)
Here you can set the location (page) in the Operating menu (in special applications only) to which
the display automatically moves as the set Timeout time (see below) has expired or as the power is
switched on to the keypad. See setting of Default page above.
Timeout time (P6.6.3)
The Timeout time setting defines the time after which the keypad display returns to the Default page
(P6.6.1) see above.
Move to the Edit menu by pressing the Menu button right. Set the timeout time you want and confirm
the change with the Enter button. You can return to the previous step anytime by pushing the Menu
button left.
Figure 79. Timeout time setting
NOTE! If the Default page value is 0 the Timeout time setting has no effect.
Contrast adjustment (P6.6.4)
In case the display is unclear you can adjust its contrast through the same procedure as that for the
timeout time setting (see above).
Backlight time (P6.6.5)
Giving a value for the Backlight time, you can determine how long the backlight stays on before
going out. You can select here any time between 1 and 65535 minutes or 'Forever'. For the value
setting procedure see Timeout time (P6.6.3).
7.3.6.7
Hardware settings
NOTE! The Hardware settings submenu is protected with a password (see Chapter Password
(S6.5.1)). Store the password in a safe place!
In the Hardware settings submenu (S6.7) under the System menu you can further control some
functions of the hardware in your AC drive. The functions available in this menu are HMI
acknowledge timeout and HMI retry.
To Next Page
Loading...
