EasyManuals Logo

Vacon NX User Manual

Vacon NX
239 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #20 background imageLoading...
Page #20 background image
3
vacon • 18 Receipt of delivery
Local contacts: http://drives.danfoss.com/danfoss-drives/local-contacts/
3.4 Warranty
Only manufacturing defects are covered by the warranty. The manufacturer assumes no
responsibility for damages caused during or resulting from transport, receipt of the delivery,
installation, commissioning or use.
The manufacturer shall in no event and under no circumstances be held responsible for damages
and failures resulting from misuse, wrong installation, unacceptable ambient temperature, running
motor with lower coolant flow than minimum flow, condensation, dust, corrosive substances or
operation outside the rated specifications.
Neither can the manufacturer be held responsible for consequential damages.
NOTE! VACON
®
NX Liquid-Cooled drives must not be run with the liquid cooling system
disconnected. Furthermore, the requirements of the liquid cooling specifications, e.g. minimum
flow rate (see Chapter 5.2 and Table 15) must be satisfied. Ignoring this will render the warranty
null and void.
NOTE! VACON
®
Liquid-Cooled NX_8 inverter unit must be equipped with a du/dt- or sine-filter. The
warranty is void in case filter are not used with these units.
The Manufacturer's time of warranty, if not otherwise agreed, is 18 months from the delivery or 12
months from the commissioning whichever expires first.
The local distributor may grant a warranty time different from the above. This warranty time shall
be specified in the distributor's sales and warranty terms. Vacon Ltd assumes no responsibility for
any other warranties than that granted by Vacon itself.
In all matters concerning the warranty, contact first your distributor.

Table of Contents

Other manuals for Vacon NX

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Vacon NX and is the answer not in the manual?

Vacon NX Specifications

General IconGeneral
Product TypeAC Drive
Control MethodScalar Control
EnclosureIP00, IP21
CommunicationEthernet
SafetySTO (Safe Torque Off)
Protection FeaturesOvercurrent, Overvoltage, Undervoltage, Overtemperature, Short Circuit
Ambient Temperature Range-10°C to +50°C (with derating above +40°C)
Cooling MethodAir-cooled, Liquid-cooled

Related product manuals