Installation vacon • 73
Local contacts: http://drives.danfoss.com/danfoss-drives/local-contacts/
5
Example: If you connect the mains cable of one phase to terminal X, the other two phases
must be connected to Y and Z. Accordingly, the choke output cables are connected to
their corresponding input pairs: phase 1 U, phase 2 V and phase 3 W.
Other types (chokes with busbar connection)
Connect the mains cables to the upper busbar connectors (see Figure 34 and Figure 35)
with bolts. The cables to the AC drive are bolted to the lower connectors. See Table 32
and Table 34 for bolt sizes.
To Next Page
Loading...
