Figure 9 Connecting cables to connector plate
1 Power connector
2 RS‑485 signal connector
3 Power connector slot +. Connect to + on the power cable.
4 Power connector slot − (ground). Connect to − on the power cable.
5 Signal connector slot 1. Connect to R/D− on the data cable.
6 Signal connector slot 2. Connect to R/D+ on the data cable.
If the display is delivered with the optional connector plate, the DIP switches are set to the
RS‑485 2‑wire mode already at the Vaisala factory. If you install the connector plate after
the delivery, set the DIP switches to the RS‑485 2‑wire mode yourself.
4.7 Installing display
You can install the display:
• with the provided display stand to a wall, table, or ceiling
• as a panel display
Chapter 4 – Installation
25
To Next Page
