More information
‣
Mounting display on display stand (page 26)
‣
Mounting display as panel display (page 27)
4.7.1 Mounting display on display stand
Figure 10 Display installed with display stand
(showing also panel mounting brackets/screws)
1 Panel mounting bracket
2 Knurled thumb screw for the display
stand
3 Protective film to be removed after
installation
4 Screws for moving the panel mounting
brackets (behind the front cover)
5 Mounting holes for inserting the
mounting screws for the stand
After connecting cables and reattaching the connectors:
1. Reattach the back cover and tighten the screws that hold the cover.
2. Reattach the front cover and tighten the fixing screws for the cover.
3. Insert the mounting screws into the mounting holes at the bottom of the stand, adjust
the stand to the required position, and tighten the screws.
4. Attach the stand to the display with the two knurled thumb screws located on both
sides of the display.
5. Once you have found the desired positioning, tighten both thumb screws.
WID511 User Guide M211109EN-L
26
To Next Page
Loading...
