6. Remove the protective film before taking the display into use.
The display is now mounted on the display stand.
4.7.2 Mounting display as panel display
After connecting cables and reattaching the connectors:
1. Reattach the back cover and tighten the screws that hold the cover.
2. Insert the display into the panel opening.
3. To move the panel mounting brackets to the front, tighten the panel mounting screws.
1 Panel mounting screw (hex screw M3×20 DIN913 A4)
2 Panel mounting screw (crosshead screw M3×35 DIN7985 PZ A4)
3 Upper mounting bracket
4 Lower mounting bracket
Chapter 4 – Installation
27
To Next Page
Loading...
