3. On the Data settings page, select how to display the data values on the ATC page.
Normal
The ATC page displays all the data values. This is the default setting.
WD50 2‑min ICAO
The ATC page presentation is similar to WIND50 display 2‑minute page with
ICAO mode ON.
• The 10‑minute wind direction variation is displayed only when the direction
is ≥ 60°.
• The 10‑minute wind speed extremes are displayed only when the dierence
between the 10‑minute minimum or maximum wind speed and the 2‑minute
average wind speed ≥ 5 m/s (10 kt/18 km/h).
4. To save the changes, press Apply.
The changes are valid only after pressing Apply.
More information
‣
ATC layout (page 33)
7.22
Setting time
You can use Network Time Protocol (NTP) as the time source or configure the time
manually.
1. Enter Maintenance mode.
Chapter 7 – Advanced settings in Maintenance mode
81
To Next Page
Loading...
