3. On the Select messages in use page, select the messages that are used in the system.
Make sure that all the needed messages are selected. If a message is
not selected, the data from the message is not displayed on the data pages and the
alerts for missing data are NOT displayed.
CAUTION!
4. To save the changes, press Save.
When taking the system into use, or when there have been changes in sensors or
communication, change the sensor and communication configuration.
More information
‣
Data sources (page 12)
‣
Configuring message and communication settings (page 68)
7.15
Configuring message and
communication settings
You can configure the settings for the message or the default sensor and other data sources.
1. Enter Maintenance mode.
2. On the Advanced settings page, press Messages.
3. On the Select messages in use page, press Configure.
WID511 User Guide M211109EN-L
68
To Next Page
Loading...
