5. On the terminal page, you can see all the incoming messages in the selected NET port.
When the terminal page is open, normal communication between the display and the
sensor stops. In the autosend mode, the display stops processing the messages coming
through the selected NET port. In the poll mode, the display stops polling the sensor.
If the terminal page is open for long, the display gives an audible alarm. When you return
to the data page, some of the data fields are empty until there is enough processed data
again.
7.20 Configuring station settings
You can configure station settings, such as declination.
1. Enter Maintenance mode.
2. On the Advanced settings page, press Station.
Chapter 7 – Advanced settings in Maintenance mode
79
To Next Page
Loading...
