When returning a product for calibration or repair, make sure it has not
been exposed to dangerous contamination, and is safe to handle without special
precautions.
WARNING!
Do not modify the unit or use it in ways not described in the documentation.
Improper
modification may lead to safety hazards, equipment damage, failure to
perform according to specification, or decreased equipment lifetime.
CAUTION!
Do not attempt to open the probe body. There are no user serviceable parts
inside the probe body.
CAUTION!
2.8.1 ESD Protection
Electrostatic Discharge (ESD) can cause immediate or latent damage to electronic circuits.
Vaisala products are adequately protected against ESD for their intended use. However, it is
possible to damage the product by delivering electrostatic discharges when touching an
exposed contact on the product.
To make sure you are not delivering high static voltages yourself, avoid touching the pins on
the M12 connector.
2.9
Regulatory Compliances
The probe is in conformity with the provisions of the following EU directives:
• RoHS Directive
• EMC Directive
Conformity is shown by compliance with the following standards:
• EN 50581: Technical documentation for the assessment of electrical and electronic
products with respect to the restriction of hazardous substances.
• EN 61326-1: Electrical equipment for measurement, control, and laboratory use – EMC
requirements – Generic environment.
• EN 55022: Information technology equipment – Radio disturbance characteristics –
Limits and methods of measurement.
GMP252 User Guide M211897EN-D
20
To Next Page
Loading...
