To use the wireless configuration interface to modify the settings of your Indigo transmitter
and the connected probe, you must first enable the transmitter's wireless connection and
then connect to Indigo with your mobile device or computer. Most major browsers (for
example, Firefox, Chrome, Safari, and Internet Explorer) are supported: using the most
recent version is recommended.
7.2 Taking a Probe in Use with Indigo
In order to use the probe with an Indigo transmitter, you need to connect the probe to an
Indigo transmitter and use a mobile device or computer to review the transmitter and probe
configuration with Indigo's wireless configuration interface.
• Indigo-compatible probe and Indigo transmitter
• Mobile device or computer that supports wireless connectivity (IEEE 802.11 b/g/n
WLAN)
• Web browser
To take the probe in use with Indigo:
1. Connect the probe to a wired and powered Indigo transmitter and check that the
transmitter recognizes the probe (green LED/display notification).
2. Enable Indigo's wireless connection and open the Indigo wireless configuration
interface in your mobile device or computer.
3. Use Indigo's wireless
configuration interface to check that the probe and transmitter
settings are correct for your system. For instructions on using the wireless configuration
interface, see the User Guide of the Indigo transmitter.
More Information
‣
Attaching Probes and Cables (page 67)
‣
Connecting to Wireless Configuration Interface (page 68)
‣
Wireless Interface Menus (page 70)
‣
Logging in to Wireless Configuration Interface (page 69)
Chapter 7 – Using GMP252 with Indigo Transmitters
65
To Next Page
Loading...
