3. Installation
3.1 GMP252 Probe Dimensions
12 mm
[0.47 in]
76 mm
[2.99 in]
42 mm
[1.65 in]
130 mm [5.11 in], Ø 25 mm [0.98 in]
M12 male
connector
Figure 6 GMP252 Dimensions
3.2
Recommended Installation
The probe can be installed in an environment with an operating temperature range -40 ...
+60 °C (-40 ... +140 °F). Make sure the probe is in a location that represents the
measurement environment properly.
The 5-pin male M12 connector on the probe provides an easy plug-in/plug-out connection to
a compatible cable.
3.3
Installation Accessories
The probe can be installed through a surface using the optional flange accessory (Vaisala
product code 243261SP), or attached for example to a wall with the optional clip accessory
(two-clip set, Vaisala product code 243257SP).
For installations where a pressure washer is used to clean the measurement area, a spray
shield with an IP9X rating (Vaisala product code ASM212017SP) is available as an optional
accessory.
If the probe is installed outdoors, the optional DTR250 radiation shield accessory can be
used to protect the probe from solar radiation and precipitation. The radiation shield can be
ordered either as a stand-alone item with an integrated mounting plate, or together with a
pole mounting kit.
Chapter 3 – Installation
21
To Next Page
Loading...
