7.3 Attaching Probes and Cables
Figure 17 Attaching Probes and Cables to Indigo
1 Insert probes into the probe connector with the orientation mark facing out.
2 Probes are locked in place with the locking wheel. Never turn from the probe body.
3 Connect probe cables in the same way as probes: insert the cable in the connector and
hold in place while turning the locking wheel.
1. Insert the probe into the probe connector with the orientation mark on the probe body
facing out.
2. Hold the probe in the probe connector and lock it in place by turning the locking wheel
counterclockwise. Never turn the probe body when attaching or removing probes, only
the locking wheel of the Indigo transmitter.
3. When the transmitter recognizes the connected probe, it shows a
notification message
on the display (for example, Probe Connected: GMP251). In the non-display model, a
green LED is lit when Indigo recognizes the probe.
Chapter 7 – Using GMP252 with Indigo Transmitters
67
To Next Page
Loading...
