3.3.2 243257SP Mounting Clips
The optional mounting clips (set of two clips) are used to hold the probe in place for
example on a wall or other surface. Each clip base attaches to the installation surface with
one screw (screw hole Ø 4.2 mm).
Figure 8 Probe in 243257SP Mounting Clips
3.3.3
ASM212017SP Spray Shield
The optional spray shield (Vaisala order code: ASM212017SP) allows washing the probe with
a pressure washer without exposing the sensor to moisture (IP9X rating).
Remove lid to clean
O-ring
Figure 9 Probe with ASM212017SP Spray Shield
The spray shield can limit or prevent the use of the probe mounting clips (243257SP).
More Information
‣
ASM212017SP Spray Shield Dimensions (page 109)
Chapter 3 – Installation
23
To Next Page
Loading...
