Vaisala GMP252 - Device Information and Status; Table 8 Advanced Serial Commands; Table 9? Command

Table 8 Advanced Serial Commands
Command Description
Serial line output and communication
addr [0 … 254] Show or set probe address.
Analog output
amode
Show or set analog output mode (analog output limits and error level).
aover
Show or set analog output overrange and clipping behavior.
asel
Show or set analog output parameter and scaling.
Calibration and adjustment
cco2
Adjust CO
2
measurement gain and oset.
cdate
Show or set calibration date.
ct
Adjust temperature measurement oset.
ctext
Show or set calibration information.
Environmental compensation
o2cmode
Show or set oxygen compensation mode.
pcmode
Show or set pressure compensation mode.
rhcmode
Show or set humidity compensation mode.
tcmode
Show or set temperature compensation mode.
Other commands
frestore
Restore probe to factory settings.
4.9 Device Information and Status
Table 9 ? Command
Syntax Description
?<cr>
Show listing of device information.
??<cr>
Show listing of device information even if device is in
poll mode and connection has not been opened using
the open command.
Chapter 4 – Vaisala Industrial Protocol
33