Figure 84 Cursor Set/Plant Tool
1. In the Cursor tool, define home points by doing one of the following:
• Use your mouse to position the cursor and select Plant Home.
The Home point, indicated by an Xmoves to the cursor.
• Select the Set Home icon to show the Set/Plant Tool.
Select a Point ID and then the Home point from the list.
6.13.2
Creating Named Home Points (Operators only)
If you have operator privilege in the window (File > Set Privilege to), you can use the Set/
Plant tool to make new named points for key locations.
1. Select . In the Set/Plant, do one of the following:
• Enter the LAT/LON of the home point and the name of the home point. You can type
the LAT/LON using either degrees and minutes or decimal degrees.
• Select Point ID and select Save.
2. Position your cursor where you want to place the home point and then click the Plant
Home icon.
a. Select Set Home to fill in LAT/LON automatically.
b. Replace the text Plant with the name you want.
c. Select Point ID and select Save.
3. To delete a home point name:
a. Using Point ID to select the point.
b. In the Point ID menu, select Delete.
The Radar is used as the home point until you select another one.
Chapter 6 – Quick Look Window
RESTRICTED 231
To Next Page
Loading...