5. To cross-section, select the XSECT icon.
6. Monitor the cross-section line configuration progress in the Status field at the bottom
of the tool.
• Range and Azimuth refer to the center point of the line.
• Status shows the progress: Setup, Running, and Done.
If the ingest data for the requested data time (that is, the time of the base product) are
not on disk, the status shows Error and a message informs you the ingest files were
unavailable. In this case, browse forward in time and try again, or check the Ingest
Summary Menu to see what data are available.
6.17 Product Output Options Tool
There are several products for which you can specify additional output options. If one of
these products is on the screen, the Output Options tool icon is enabled.
The Output Options tool allows you to adjust the display of these products for your
application.
You can then select File > Save for the VVP, WIND/FCAST, and NDOP options to save the
configuration for your window is saved (it does not aect other windows).
If you are using
WIND, FCAST, or NDOP products as overlays on other products, it is
sometimes convenient to display (for example) the WIND, product and the options tool
for WIND. Then leave the tool up so you can use it if needed when you look at WIND
overlaid on another product.
Chapter 6 – Quick Look Window
RESTRICTED 247
To Next Page
Loading...