1. Select File > .
The product information window opens with the following information about the
currently selected 3D data product:
• Data:
Data type being displayed
• Time:
Timestamp of the data file
• Volume:
Size of the radar data volume
• Radar:
Name and location of the radar that produced the data file
• Color legend for the 3D view
2. To define how the data product is rendered in the 3D view, use the following options:
• Color map:
Allows selection from a short list of pre-configured color scales.
• Rendering mode:
Rendering mode of the 3D visualization. Options are: surface rendering and volume
rendering.
• Isosurface parameters:
These options are visible if surface rendering has been selected as the rendering
mode. Using these options you can define the following options for surface
rendering:
• Number of isosurfaces (1 ... 4)
• Threshold value for each isosurface
• Opacity of each isosurface
• Color of each isosurface
3. If you have selected volume rendering as the rendering mode, you can define the
following Volume parameters for volume rendering
• Low and high value of the rendered range
• Opacity at the low and high end of the rendered range
• Color at the low and high end of the rendered range
4. Do one of the following:
• Select Apply to save your changes.
• Select Revert to previous to restore the previous settings.
• Select Reset to defaults to select the surface rendering mode with the default
isosurface settings.
5. To minimize the window, select the small arrow at the bottom right corner.
In the minimized form, the product information tool shows only the color legend.
C.9
Using the IRIS 3DView Cursor Tool
The cursor tool displays information about the current home location, and the current cursor
position in relation to the home position.
IRIS Product and Display User Guide M211319EN-H
328 RESTRICTED
To Next Page
Loading...