Figure 123 Ribbon Display Setup Menu
The bottom of the setup menu has 9 entries for each display, corresponding to the 9 lines
that are available for warnings on a ribbon display. To configure what appears on each line,
first highlight the line and then right-click the mouse to get a pop-up list of all possible
corridors as shown below.
The corridor names are taken from the IRIS setup/product warning areas that were created
(see the beginning of this section). In addition, there is a blank line (to configure blank lines
on the display), and there are other arbitrary protected areas that may not be associated
with a particular corridor. For example, a single large protected area could be configured to
display alerts anywhere within 8 km (5 miles) of the terminal.
IRIS Product and Display User Guide M211319EN-H
350 RESTRICTED
To Next Page
Loading...