Vaisala IRIS - Figure 114 Cursor Tool

Figure 114 Cursor Tool
1. Select File > .
The cursor tool window opens and a round cursor with yellow axis lines appears on the
3D view area.
2. Use the mouse to drag the cursor around the view area.
Position the mouse pointer above the cursor or one of the axis lines, hold down the left
mouse button, and move the mouse.
As the cursor moves, the cursor tool window is updated with the location and value
information at the cursor position.
To move the cursor only on horizontal or vertical axis, hold down the shift key when
moving the cursor.
You can also change the current home position by selecting a radar site from the
drop-down list, or selecting Set home with cursor.
3. To minimize the window, select the small arrow at the bottom right corner.
In the minimized form, the cursor tool only shows the information for the current cursor
position.
Appendix C – IRIS 3DView
RESTRICTED 329