1. To send existing products:
a. Select Device.
b. Select the device to which you want to send the product.
c. Select the products you want to send by doing one of the following:
• Left-click the mouse over a list item.
Press CTRL+click to select more than one entry in the list.
• Click and drag the mouse to select a group of entries in the list.
Press CTRL+click and drag the mouse to select multiple groups of entries.
• Use the Filter menu to produce a list of the products that you want to send.
d. Choose Send from one of the following menus:
• If you selected the entries with the mouse, position the cursor over the request
column and right-click the mouse.
• If you selected the entries from the Filter menu, select Commands.
e. Select Send:
The product is marked to be sent to the selected device and is waits for the output
formatter to send it.
The sending status is shown with the following indicators:
Sending
The output formatter is working on your request.
Done
The product has been sent to the selected network device.
----
There is currently no request.
Error
An error occurred. Check the Radar Status menu.
If the selection contains both headers and products, the command applies only
to the products.
To perform an operation on headers, you must select only headers.
2. To send one or more future versions of a product:
a. Select the header for the type of product you want to send.
b. Right-click the request column to select any number of sites that are known to your
system to receive all or the next version of the product.
A send request is issued automatically when a new version of the product is added to
the disk.
A send status message appears in the Request column.
3. To cancel a send request, place the cursor over the Request column and select Cancel.
If you select a single product, you cancel only the send request for that product.
To cancel the request for future products, right-click the request column and deselect
the site.
Chapter 7 – Requesting Product Output
RESTRICTED 267
To Next Page
Loading...