1. Select Menus > Ingest Summary.
The Ingest Summary list in the bottom pane is sorted by time, with the newest files
listed first.
Tag
Displays k for keep, d for delete, or blank if no flag is set.
Site
Shows the site ID for the radar site from which data were gathered.
TASK
Contains the name of the task.
Scan
Contains type of scan used to collect the data, such as RHI or PPI.
Range
Contains the value of the Max Range field, taken from the task configuration.
Data
Lists the data parameters (Z, T, V, W) for the task.
Sweeps
Shows the number of sweeps that were collected by the task. If the scan was
halted prematurely, this column displays the partially completed task as N/M,
even if the task was halted during the final sweep.
Start Time
Shows the time that the task started to collect data.
Size
Shows the total amount of disk space occupied by the ingest files for this run of
the task.
2. Select an entry in the list and position the mouse cursor over any of the fields to show
the following options:
• Keep tags all selected files with the keep flag so they are not deleted by the
Watchdog.
This is necessary if you want to save ingest files, including those that have been
restored from tape, for non-real time product generation in an analysis mode. For
example, you might want to make a product tomorrow from today's ingest data.
See Tagging and Untagging Ingest Files (page 286).
• Clutter tags a selected file as a clutter map.
• Un-Tag removes delete or keep flags from the selected files.
• Delete tags all selected files with the delete flag to free more disk space for new
ingest files.
IRIS Product and Display User Guide M211319EN-H
284 RESTRICTED
To Next Page
Loading...