4. The IRIS 3D View application is in the rpm package called iris3dview-
1.0.2-1.i686.rpm. Install it using the rpm installation tool
# rpm -Uvh iris3dview-1.0.2-1.i686.rpm
It is recommended that you do not run the IRIS 3D View application while logged in
as a root user.
If you have IRIS software installed on your system, log in as radarop user.
If IRIS software is not installed, create a user on your system.
5. In the GNOME window, create a user by selecting System > Administration > Users
and Groups and follow the online instructions.
6. Log in as normal user and check .config/Vaisala directory for the following files:
• IRIS3D.conf
• IRIS3DColors.conf
• IRIS3DLandmarks.conf
• IRIS3DVisStyles.conf
7. Do one of the following:
a. If you have the IRIS software installed, create the following directories:
/usr/iris_data/data/geo # for geo data
/usr/iris_data/data/2d # for 2d data
/usr/iris_data/data/3d # for 3d data
/usr/iris_data/data/background_output
# for background images processing results
The permissions and ownership for these directories are:
drwxrwsr-x
2 operator users 4096 Dec 11 13:14 2d drwxrwsr-x
2 operator users 4096 Dec 11 13:15 3d drwxrwsrwx
2 operator users 4096 Dec 11 13:15 background_output drwxrwsr-x
2 operator users 4096 Dec 11 13:14 geo
b. If you do not have the IRIS software installed, you can put your data directory
anywhere you want, but you must set the directory permissions to read/write
access.
IRIS Product and Display User Guide M211319EN-H
314 RESTRICTED
To Next Page
Loading...