The features of the menu are described in detail below.
File
This provides the functions
• Load
Used to restore the menu from the currently-saved file configuration if you want to
"undo" changes.
• Save
Saves your changes.
• Print
To print the menu for documentation purposes.
• Exit
To exit the menu. Note that ribbon displays remain active when you exit.
Status
Select Status to see a submenu of the communication status of each of up to 8 ribbon
displays that can be attached to your IRIS workstation.
The top row of the menu shows the ribbon display numbers for 8 displays that could
be connected to your IRIS workstation. Note that your system may have fewer than 8
displays. The second row shows the names that have been configured for the displays.
The last four names are set to "none" to indicate that these are unused.
The status of each ribbon display is indicated as OK or Dead. A Dead display may
have been turned-o or have a cabling problem. Also, the display number set on the
display itself may be incorrect (see Dale Ribbon Display General Use (page 344)).
The update time shows the time in seconds since the last communication between
IRIS and the display. Input and output count are shown to indicate the number of
bytes input from the display and output to the display. This is sometimes useful for
debugging communications problems.
Config
The submenus under config provide the ability to customize the appearance of each
ribbon display.
IRIS Product and Display User Guide M211319EN-H
348 RESTRICTED
To Next Page
Loading...