Create the directory /usr/iris_data/tdwr
You must have root privilege for this step. The tdwr directory can exist anywhere on the
workstation that runs the Integrator. However, we recommend that you put it in the same
place that you put the IRIS_PRODUCT product directory.
For a standard installation this is in a directory called /usr/iris_data. This may be
dierent on your system. To see the location of the product directory check /usr/
sigmet/config/profile.
To make the tdwr directory, log in as root or become the super user and type:
# cd /usr/iris_data
# mkdir tdwr
Set the privileges for the directory to match the other directories (do an ls –ll to see how
the other directories are set). For a standard installation type:
# chown operator tdwr
# chgrp users tdwr
# chmod 777
Install the runways.conf file
The runways.conf file is kept in the /$IRIS_ROOT/config directory (usually /usr/
sigmet/config).
Check if the file exists in this directory. Log in as operator and type:
$ cd /usr/sigmet/config
$ ls
Check that the runways.conf file is in the list. If it is not, copy the template as follows:
$ cp /usr/sigmet/config_template/init/runways.conf /usr/sigmet/config
Edit the runways.conf file
Edit the runways.conf file (use vi, emacs, or your ASCII text editor). The file is shown
below:
Appendix D – IRIS TDWR Features
RESTRICTED 355
To Next Page
Loading...