Van's Aircraft RV-12 Maintenance Manual

Rev.2
14-3
GENERAL
EXHAUST SYSTEM REMOVAL
▲
WARNING:
A
LLOW THE EXHAUST COMPONENTS TO COOL BEFORE PERFORMING
INSPECTION OR SERVICE.
Tools
13 mm socket
Locking pliers
Expendable
Anti-seize compound, high temp
Replaceable
Joint spring
Service Rating
Line
Minimum Certification
LSA-RM or A&P
Additional References
KAI
1. Remove the engine cowling. (12-4)
2. Remove the muffler attachment springs (8) and muffler. Note: To avoid nicking
the springs clamp a short loop of safety wire in locking pliers. Hook the loop onto
the spring and then pull to remove the spring.
3. Remove the two nuts, two washers and the exhaust tube from each cylinder
exhaust port.
INSTALLATION
1. Lubricate the ball joints and all exhaust hardware. (14-4)
2. Installation procedure is reverse of the removal procedure.

Van's Aircraft RV-12 Specifications

General

Brand	Van's Aircraft
Model	RV-12
Category	Aircrafts
Language	English