Rev. 5
3-7
RADIO
• Check the connections, external condition, and installation of each component; the
main unit, the antenna and the jacks.
COMMUNICATION
• Test the operation of the unit per manufacturer specs. (Refer to the Garmin or
Dynon installation manual)
INTERCOM
• (If Installed) Test the operation of the unit per manufacturer specs. (Refer to the
FlightCom manual)
TRANSPONDER
• Make sure the transponder is in compliance with FAR 91.403 and log entries
current.
OPTIONAL EQUIPMENT
• Confirm that optional equipment installed on the aircraft is correct and authorized.
Optional equipment is offered and installed on the aircraft by the manufacturer at the
time of purchase. Refer to the related manual for special procedures for inspection.
(See applicable manual provided with the component)
EMERGENCY LOCATOR TRANSMITTER
• The ELT must be inspected in compliance with the FAR Part 91.207 (d) and
accompanied by a logbook entry.
PROPELLER
(Refer to Sensenich Propeller manual)
HE MASTER POWER AND BOTH IGNITION SWITCHES
BE SHUT
OFF DURING INSPECTION OF THE PROPELLER
. SERIOUS INJURY OR DEATH WILL
RESULT IF ENGINE IS UNINTENTIONALLY STARTED BY TURNING THE PROPELLER.
• Check the spinner cone and back-plate fasteners for wear and security.
• Inspect hub and fasteners for cracks and wear.
• Check the pitot tube and bushing for wear and condition.
• Check hub fastener torque.
• Inspect the leading edge of the blades for loose metal. Inspect each entire blade for
To Next Page
Loading...
Need help?
General
