EasyManuals Logo

Van's Aircraft RV-12 Maintenance Manual

Van's Aircraft RV-12
217 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #39 background imageLoading...
Page #39 background image
Rev. 5
3-3
INSPECTION DESCRIPTION
PRE-INSPECTION / POST-INSPECTION
Perform the preliminary systems check and engine run-up. The Rotax line
maintenance manual provides the run-up procedure for the engine. Test all of the
engine systems and controls. Test all of the airframe systems and controls. Make note
of any abnormalities or dysfunctional components. Record the applicable values in the
spaces given on the Inspection Checklist. After the systems check, proceed with the
following:
1. Remove the left and right wing.
2. Remove all access covers, inspection plates, fairing and cowling shown in
Figure 4.
Tools
3/8 socket
#2 Phillips screwdriver
Service rating
Line
Minimum Certification
LSA-RM, or A&P
TOOLS
Inspection Mirror
Clean rags
Straight edge (avoid scratches; tape
along one edge)
Small square
Screwdrivers:
#2 Phillips
Socket:
3/8
Multi-meter
Compression tester
Torque wrench (in/lbs & ft/lbs)
Tire pressure gauge
Jack
Padded stands
Step ladder
Flashlight
Magnifying Glass
Wing Retention Pin Bushing Gauge
CAUTION:
A
LWAYS SUPPORT THE FLAPERON DURING WING REMOVAL AND
STORAGE.

Table of Contents

Other manuals for Van's Aircraft RV-12

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Van's Aircraft RV-12 and is the answer not in the manual?

Van's Aircraft RV-12 Specifications

General IconGeneral
BrandVan's Aircraft
ModelRV-12
CategoryAircrafts
LanguageEnglish

Related product manuals