Rev. 5
3-8
cracks, missing material, and delamination.
ERFORM THE PROP TRACK TEST WITH THE SPARK PLUGS REMOVED
• Test prop track by placing a stationary object in contact with the forward or aft face
of one of the blade tips. Then rotate the propeller to bring the opposite blade to the
same point. An off-track propeller will not come to the same point.
ENGINE
(Refer to Rotax manual)
HE MASTER POWER AND BOTH IGNITION SWITCHES
BE SHUT
OFF DURING INSPECTION OF THE ENGINE
, UNLESS INSTRUCTED OTHERWISE. SERIOUS
INJURY OR DEATH WILL RESULT IF ENGINE IS UNINTENTIONALLY STARTED
.
LLOW THE ENGINE AND APPLICABLE COMPONENTS TO COOL
BEFORE PERFORMING SERVICE OR INSPECTION
. HOT ENGINE COMPONENTS WILL
• Refer to the Rotax line maintenance manual for proper inspection procedure for
engine and components supplied with engine. The Rotax manual will also provide
fluid check and change procedure.
FIREWALL FORWARD
HE MASTER POWER AND BOTH IGNITION SWITCHES
BE SHUT
OFF DURING INSPECTION OF THE FIREWALL FORWARD COMPONENTS
. SERIOUS INJURY
OR DEATH WILL RESULT IF ENGINE IS UNINTENTIONALLY STARTED
.
LLOW THE ENGINE AND APPLICABLE COMPONENTS TO COOL
BEFORE PERFORMING SERVICE OR INSPECTION
. HOT ENGINE COMPONENTS WILL
♦
♦ Flashlight
♦ Inspection mirror
♦
♦ Compression
tester
♦
• Note any signs of leakage, corrosion, and high temperature. Check for wear to
hoses, cables, wiring harnesses, etc. as a result of vibration while in contact with
another object.