To clear the internal registration:
l On the WRMT, press and hold the PARTSET and UNSET buttons.
The LED blinks Red and Orange to confirm that registration is cleared.
17.9.2.5 Changing wireless settings
To change wireless settings, select Configuration > Hardware > Wireless > Wireless Settings.
See table below for further information.
Two Way
Wireless
Enable or disable two-way wireless depending on the transceiver you are using.
Enable two-way wireless if you are using SPCW120 Wireless Transceiver.
Disable two-way wireless if you are using SiWay RF Kit (SPCW110, 111, 112, 114 ).
Filter Click to filter low strength RF signals.
Detect RF
JAM
Click to activate an alert if RF interference is detected.
Wireless
Lost Event
Click to send Wireless Lost event over CID/SIA and FlexC.
Supervision Set the amount of time in minutes between occurrences of two way wireless signal supervision.
Antenna Select the type of antenna connected to the wireless module (internal or external) from the drop
down menu. The type of antenna required for the wireless module depends on the type of wireless
module fitted.
Missing
Supervision
Select whether a wireless sensor that is reported as missing registers a tamper condition on the
signet panel.
A wireless sensor is reported as missing when no supervision signal has been received from the
sensor for a period greater than the programmed Wireless Lost timer. See Timers on page261.
SPC4xxx/5xxx/6xxx – Installation & Configuration Manual Engineer programming via the browser
© Vanderbilt 2018 227 A6V10276959-d
11.2018
To Next Page
Loading...
Need help?
General
