Description Enter a text describing the input (max. 16 characters). This text will also appear
on the browser and keypad.
Type The type of zone (see Zone types on page379).
Area Only if (multiple) Areas is activated in menu Panel Settings > System Settings
> Options. Select the areas to which this zone has been assigned.
Attributes An icon in this field indicates that attributes have been programmed for this zone
(see Input zones: attributes below).
Input zones: attributes
Each zone on the SPC can be assigned an attribute that determines the properties of that zone.
To assign an attribute to a zone:
1. Select Configuration > Hardware > Controller > Attributes.
The following page will be displayed:
2. Check the box beside the preferred attribute.
The attributes presented on this page will depend on the type of zone selected. For a list of
assignable attributes, see Applicable attributes to zone types on page387.
SPC4xxx/5xxx/6xxx – Installation & Configuration Manual Engineer programming via the browser
© Vanderbilt 2018 230 A6V10276959-d
11.2018
To Next Page
Loading...