The Early/Late parameter is enabled to report any setting or unsetting which differs from the schedule.
Enable Reporting of Unusual Setting/Unsetting for SMS
SMS Events can be configured using both Engineer and User configuration pages.
For Engineer configuration, select Users > Users SMS > Engineer SMS > Edit.
Enable Early/Late to report any setting and unsetting which is not according to schedule.
Setting/Unsetting
The following parameters (with the exception of the Interlock parameter) are only relevant in the following
cases:
l A Calendar is selected (see Schedule on page273), or
l Unset Duration is enabled (has a value greater than zero), or
l Both of the above conditions are met.
Auto Set
Warning
Enter the number of minutes to display a warning before Auto Setting. (0–30)
Note that the panel sets either at the scheduled time or at the time defined by the Delay Unset
parameter. The first warning is displayed at the configured time before the scheduled time. There are
further warnings starting at one minute before setting time.
Auto Set
Cancel
Enables the user to cancel Auto Setting by entering a code in the keypad.
Auto Set
Delay
Enables a user to delay Auto Setting by entering a code in the keypad.
Keyswitch Enables Auto Setting to be delayed using Keyswitch Expander.
Delay
Interval
Enter the number of minutes by which to delay Auto Set. (1–300 )
Delay
Counter
Enter the number of times that Auto Setting can be delayed. (0–99: 0=unlimited)
Delay
Unset
Enter the number of minutes by which to delay an Unset. (0=nodelay)
SPC4xxx/5xxx/6xxx – Installation & Configuration Manual Engineer programming via the browser
© Vanderbilt 2018 275 A6V10276959-d
11.2018
To Next Page
Loading...
Need help?
General
