Incoming
Calls
Note: Vanderbilt recommend that these options are not enabled for current systems.
The modem can be programmed to answer calls based on the following conditions:
l Don’t answer incoming calls: The modem never answers calls.
l Answer incoming calls: The modem answers incoming calls.
l Only answer when ‘Engineer Access’ is granted: The modem only answers the call while
engineer access is granted to the system.
Line
Monitoring
l Disabled
l Enable
l Fullset
Enable this feature to monitor the signal level from the GSM mast connected to the modem.
The Fullset option only enables this feature while the system is Fullset.
Note: EN 50131-9 Confirmation configuration — In order for EN50131-9 Confirmation to operate
correctly, line monitoring must be enabled. (See Options on page252.)
Monitoring
Timer
Enter the time period in seconds for which the signal level must drop to Low before the SPC
system registers a fault. 0 to 9999 seconds range.
Modem Fault
Time
Enter the time delay in seconds before the SPCsystem sends an alert. 0 to 9999 seconds range.
SMS Enable Tick this checkbox to enable the transmission and reception of SMSmessages and command
control.
Automated
SMS
l Disabled
l 1 hour
l 24 Hours
l 48 Hours
l 7 Days
l 30 Days
Select the timing for automated SMS messages.
Automated
SMS Number
Enter SMS number to receive automated SMS messages. Only one device can receive these
messages.
Start
Date/Time
Enter the start date and time from when the system will send automated SMS messages.
Mobile Data Configuration
Access Point
(APN)
Enter Access Point details to enable any IP communications. These details are service provider-
dependent.
Access Point
User Name
Enter Access Point details to enable any IP communications. These details are service provider-
dependent.
Access Point
Password
Enter Access Point details to enable any IP communications. These details are service provider-
dependent.
SPC4xxx/5xxx/6xxx – Installation & Configuration Manual Engineer programming via the browser
© Vanderbilt 2018 300 A6V10276959-d
11.2018
To Next Page
Loading...