Vacuum Packaging Machine VC999 K7
Setting up the machine
2008-11-26 Art.-No. 592.016 Page 25/121
5 Setting up the machine
This section is aimed at the "service engineer" responsible for setting up the Vacuum Packaging Ma-
chine, connecting it, making it ready for use and commissioning it. It contains all the information needed
for this.
5.1 Preparation
Before the Vacuum Packaging Machine can be set up and made ready for use, the site needs to be
prepared. The technical documents and diagrams for your VC999 K7 Vacuum Packaging Machine are
in the appendix to these operating manual.
5.1.1 Site requirements
The requirements for the site are as follows:
NOTICE
The machine should not be operated in potentially explosive atmospheres!
• The site must be dry and well-ventilated.
CAUTION
If the humidity is too high, problems may arise with the control or vacuum systems due to con-
densation.
• The ambient temperature should be between 5 °C and 25 °C.
Lower ambient temperatures will result in excessively high pump starting currents, with consequent trip-
ping of fuses. With higher ambient temperatures cooling of the motors and electronics can no longer be
guaranteed.
• If water is used in the vicinity of the site, the Vacuum Packaging Machine should be protected
against the direct impact spraying and splashing water or water jets.
5.1.2 Space requirement
Space requirements for servicing and maintenance
The machine must be accessible from all sides for servicing and maintenance.
Give due consideration to free space above the machine. It should be possible to open the vacuum
chmber lid fully at all times without obstruction for maintenance purposes.
NOTICE
See section 3.3.1 “Dimensions” for machine dimensions.
To Next Page
Loading...