Vacuum Packaging Machine VC999 K7
Operation
Page 66/121 Art.-No. 592.016 2008-11-26
9.10 Programming
We recommend you to first define the programs on paper before entering them. This will give you a
clearer overview and ensure that programs will not be lost even in the event of a defect or a manipulat-
ing error on the control system. You will find appropriate program tables for copying in the Appendix.
The following descriptions outlines the necessary work steps in a chronological sequence. The detailed
work steps as well as the meanings of the parameters are explained in the relevant descriptions of the
masks.
NOTICE
If the function "Time-based vacuuming" is switched on in Mask 157: Defect modes, programs
can neither be loaded nor saved.
9.10.1 Define program
If you want to create a new packaging program, proceed as follows:
1. Enter the password to unlock step 2.
2. Ensure that "Time-based vacuuming" is switched off in Mask 157: Defect Mode
3. Set the parameters Parameter 1/2 and 2/2 in Mask 101/102.
4. Press Save program
and enter the program name via the displayed keypad.
5. Press Load program
and then the displayed program name.
6. Answer the subsequent prompt with YES. The program is saved in the current program directory,
loaded and displayed on the screen.
9.10.2 Load program
The message "Program load" refers to the call-up of a program to the working storage. You can edit a
program located in the working storage or start it for the packaging process in the corresponding step.
If you want to load an existing packaging program, proceed as follows:
1. Press Load program
and then the program name in the list.
2. Ensure that "Time-based vacuuming" is switched off in Mask 157: Defect Mode!
3. Answer the subsequent prompt with YES. The program is loaded and displayed on the screen.
To Next Page
Loading...
