Vacuum Packaging Machine VC999 K7
Repairs
Page 92/121 Art.-No. 592.016 2008-11-26
12 Repairs
This section contains information on how to remedy faults. It describes how to dismantle, replace and
re-assemble parts.
CAUTION
Risk of acid burns! Wear safety goggles and gloves.
CAUTION
Risk of crushing. Always switch the Vacuum Packaging Machine off first and make sure that it
cannot be switched on again inadvertently before starting repair work.
After each repair
Check replaced or repaired parts and perform a test run.
NOTICE
Only use original spare parts. If non-original spare parts are used, Inauen Maschinen AG cannot
accept any liability in the event of damage.
12.1 Replacing the conveyor belt
The conveyor belt will have to be replaced in the event of mechanical damage to the belt, or if you wish
to continue working with a different type of belt for operational reasons.
NOTICE
Select a conveyor belt with the dimensions given in the technical data in chapter 3.3 „Technical
data“.
NOTICE
Tension the conveyor belt after replacement in accordance with section 11.4 „Tensioning the
conveyor belt".
To Next Page
Loading...
