Vacuum Packaging Machine VC999 K7
Operation
2008-11-26 Art.-No. 592.016 Page 65/121
Parameter Function
Possible
settings
Factory
setting
Single cycle short
Operation of a single cycle in position "on":
Packaging cycle – Conveyor belt transport
Operation of a single cycle in position "off":
Conveyor belt transport – Packaging cycle –
Conveyor belt transport
on
off
off
Fan after-run
Input 0.0:
The fan of the bag waste suction unit switches
off as soon as the vacuum chamber lid reach-
es the target position during opening (at the
very top or the intermediate position).
Input 0.1 – 5.0
The fan continues to run for the time period
programmed here after reaching the target
position
The fan is switched off at the latest when the
lid is lowered.
0.0 – 5.0 s 0.0 s
Vacuuming start
delay
Delays the time between closing of the vac-
uum chamber and vacuum start.
0.0 – 2.0 s 0.8 s
Pressing time Sealing bar pressing time before sealing is
performed.
0.0 - 5,0 s 1.0 s
Pressing time
extension
The pressing time of the sealing bars is ex-
tended. Switch on the function "Intermed.
ventilation" in Mask 156: Service parameter.
This ensures that no air can flow back into the
bag.
0.0 – 5.0 s 2.0 s
Sealing bars lifting
time
Time available for the sealing bar to release
the bag before ventilation.
0.0 – 5.0 s 1.5 s
Motor current This ensures that drive motor overload can be
recognized by the conveyor belt.
0.5 ... 6.0 A *
Temperature unit
Temperature unit display °C / °F °C
* According to the name plate +10% from the drive motor
NOTICE
If the parameter "Short packaging cycle" is switched on, there is a high risk of collisions when
sealing high products!
9.9 Step 4
Access to step 4 is password protected and only for VC999 service engineers.
To Next Page
Loading...
