Vacuum Packaging Machine VC999 K7
De-commissioning / Interim storage / Disposal
Page 96/121 Art.-No. 592.016 2008-11-26
14 De-commissioning / Interim storage / Disposal
This section is aimed at the "service engineer" who shuts down, stores or disposes of the Vacuum
Packaging Machine at the end of its service life.
14.1 De-commissioning and dismantling
1. Switch the power off and disconnect the power supply line from the terminal block on the control
unit of the Vacuum Packaging Machine before starting actual dismantling work.
WARNING
Risk of electric shocks. Before dismantling the Vacuum Packaging Machine, make sure that the
power supply is properly disconnected!
2. Fix the Vacuum Packaging Machine to a crane or lifting truck (see section 4 „Packaging and trans-
port “), and transport to the scheduled site.
14.2 Interim storage
Note the following points if you wish to store the Vacuum Packaging Machine in the interim for later use:
• Clean the machine before interim storage. Take care to remove any food residues in particular.
• Change the oil.
• Store the machine in a dry room with no major temperature variations.
Make sure that the following storage conditions are observed:
• Storage temperature: -10 °C to +70 °C
• Air humidity: 60% max.
IMPORTANT
Servicing is not required during interim storage.
To Next Page
Loading...