Ventec Life Systems V-Home - Starting Oxygen Therapy with V*Home

Operating Instructions
VentecLife.com 122
Starting Oxygen Therapy
V*Home can provide oxygen therapy using a low pressure oxygen source. To congure Oxygen therapy presets, select a
preset and then press the SETTINGS & ALARMS button. Use the blue START button to activate an oxygen preset.
NOTE: Oxygen therapy can be hazardous to patients with certain medical conditions. Always seek professional medical
advice before using V*Home to provide oxygen therapy to a patient
WARNING: Do not smoke near elevated oxygen levels. Smoking near elevated oxygen levels greatly increases the
risk of re, and may result in facial burns or death. Do not smoke in the same room as, or produce open ames within
2 meters of, a running oxygen concentrator or other oxygen sources or accessories that are in use. Leave the room
containing the oxygen source if smoking.
WARNING: Do not bleed oxygen into the Ventec One-Circuit from an external source not connected to one of the
VOCSN oxygen input ports. Bleeding oxygen directly into the Ventec One-Circuit may increase the patient’s tidal
volume, or affect breath triggering.
STOP OXYGEN
0 5 10 15 20 25 30
EXIT
L
H
SETTINGS
& ALARMS
No Alarms
PRESSURE (cmH20)
NOW ACTIVE
O2 Bleed In
Low Pressure O2
PRESET 1
21 30 40 50 60 70 80 90
100
CALCULATED FiO2 MONITOR %
SIMV-VOL
V
This preset is
providing
therapy
Press here to
EXIT this
screen
Press here if
you need to
change a
control