Setup
VentecLife.com 19
The Power Supply
The power supply included with V*Home is part of the ventilation system,
and powers the device from AC wall outlets.
Before and during use, periodically inspect the power supply for damage
or frays, and to ensure the power supply cords are rmly connected. Do
not use damaged power supplies. Replace the power supply if necessary.
The power supply includes a wire retention clip. To ensure the cabling
remains seated in the adapter, rotate the retention clip so that it
secures the cable to the adapter.
The power supply also comes with a hook-and-loop strap to manage
excess cabling. Coil extra cabling between the outlet and VOCSN, and
then wrap the strap around the cabling to secure it.
NOTE: Position V*Home so that it can be easily disconnected from the
AC supply mains. To disconnect V*Home from the AC supply mains,
unplug the power supply from the outlet.
NOTE: Do not use portable (e.g., external 115‑volt AC) power supplies
to power V*Home, unless the power supply voltage variations are known to be within V*Home operating limits. See
“External Power Requirements” on page 153.
To connect V*Home to a continuous source of external power using the AC Adapter:
1 Plug the power supply into the power connection port on the back of V*Home, and screw the connector
clockwise to secure it in place.
2 Plug the power supply into a power socket, such as a wall outlet, and verify the external power indicator ( )
appears on the touchscreen.
ROTATE SCREW COLLAR ONLY
DO NOT ROTATE CABLE
To Next Page
Loading...
