Select the device to be modified in the device list;
Modify device information;
Click the Modify button to modify device information.
Click the Save Configuration button to make the device adding take effect, the same as adding a new device.
After you perform the adding, modifying or deleting operations in the Add/Modify/Delete Device page, the
configuration command takes effect without clicking the Save Configuration button. When you leave the page, a
message will pop up as shown in the Figure 3-83, prompting the user to save the configuration.
Figure 3-83 Tip
2) Install/uninstall device type
Click the Device Management submenu under the Configuration Management menu, then click the
Install/Uninstall Device Type tab to pop up the page as shown in the Figure 3-84.
Figure 3-84 Install / uninstall device type
Click the Choose File button to upload the driver configuration package (.iru file format) from the local directory, click
the install button to install the new device type.
Notices
The number of device types supported by the system depends on the remaining space of the system and the size of the driver
configuration package itself, but no more than 64.
The lower right part of the page displays the device type information of the installed device. Click the Uninstall button
to pop up the confirmation dialog box. Click the OK button to pop up the User Security Verification dialog box, enter
the current user's login password, and click the OK button to uninstall the corresponding device type.
Notices
1. During installation, if the device type exists and the device driver version is higher than the driver to be installed, the device
type cannot be installed repeatedly;
2. If the installation package does not have version information or the version information does not match the software version,
the device type cannot be installed.
3. If a device uses this device type, the Uninstall button will be grayed out and the device type will not be uninstalled during use.
b) Signal setting
Click the Signal Setting submenu under the Device Options menu to pop up the page as shown in the Figure 3-85.
To Next Page
Loading...