Vertiv | NetSure™ 8200 Series -48 VDC Power System Installation Manual (IM582140000) | Rev. A
Final Steps
Procedure
1. If any controller configuration settings were changed, refer to the NCU instructions (UM1M830BNA) and
save a copy of the configuration file. This file can be used to restore the controller settings, if required,
at a later date.
NOTE!
Provided on a USB drive furnished with the system is a controller configuration drawing (C-
drawing) and the controller configuration files loaded into the controller as shipped.
2. Verify all rectifiers and the controller are fully seated and secured.
3. Verify there are no external alarms and the local indicators are as shown in Table 16.
To Next Page
Loading...
Need help?
General
